Rose joint track rod ends

[blacknovagsi]

Eyup people, i'v been thinking of trying this for a while, i need to know however, what thread is on the oe track rods going into the ends. Also where would i get them from and how much am i looking at?:roll:

[Welsh Dan]

They're tapered on the steering knuckle if I remember correctly. I'd drill them out to a normal hole then tap them.

http://stores.ebay.co.uk/McGill-Motorsports_Metric-Male-Rose-Joints_W0QQcolZ2QQdirZ1QQfsubZ5570178QQftidZ1QQtZk m

[loggyboy]

Very harsh environment and a vital part under a lot of strain. So youd want the best. If HH uniballs for the bottom joints are £200+ then id expect a similar figure for R/Js of a spec to suit.

[Stuart]

why would you thread the knuckles? NO NEED!!!!