Fuel Pipe I/D

[Graeme]

Can any one tell me what this should be as my original ones are knackered and I've just bought some replicas made in Stainless and I suspect they are a little thin due to the material used being a lot thicker. I will be running a Let and a Bosch 044 (I think) pump and just wondered if anyone used over sized pipe to make there own, the lines will be taking the standard rote as the car is going to have a full trim
Thanks

[tony k]

your best bet is too get some copper pipe its called microbore. and 8mm should be ok you can get some from a good hardware shop. thats what my mates have run on theres for years plus ive just bought some.i think its about 15 quid a roll