Clock Needles

[Adam Moran]

How the feck do you get these off?? I'v tried pulling but the little black disk just starts to bend!

Need your help guys

Aj

[MattyWoo]

I think there is a guide in the mods section on http://www.novamad.co.uk[/url]

[ade]

1st - take a look at novamad.net however the pic you need is missing.

1 - prise needle over the bottom stop (that little plastic black pin thing)
2 - see where it comes to rest naturally
3 - mark a point on the edge of the dial housing to line the needles up afterwards
4 - take 2 tea spoons
5 - place a spoon either side of the centre piece like you were gonna take a scoop of pudding - wedge the end of the spoon under the centre piece
6 - push down gently
7 - the needle will ping off at 100 mph!
8 - hunt for needle for about an hour!
9 - fir new dials
10 - paint needle if necessary
11 - before replacing needle - line up gently with mark on edge (otherwise it will be out)
12 - when lined up - press down hard - it should click in place
13 - make sure when you do the same for the fuel gauge you carry a spare can of fuel with you coz theyre usually out! - mine read 1/4 full and was in fact empty - I ran out of fuel going to work!

Thats it.