Cheers!
Typical.. the same place i got the rosejoints from!
Not cheap tho!
Anyone know of any m10 washers that have a small outside diameter? or know of the word that might be used for such washers (ie opposite of a penny washer)
Cheers!
Typical.. the same place i got the rosejoints from!
Not cheap tho!
Anyone know of any m10 washers that have a small outside diameter? or know of the word that might be used for such washers (ie opposite of a penny washer)
M6/M8 penny washers with a 10mm hole drilled in the middle?
Yeah i think thats what i may do, open up an m8 flat washer. Just a pain as i dont have a pillar drill so its difficult to hold them and drill them!
Mole grips?
il try to get a big vice!
is it the same for an aftermarket quickshift linkage?
and what is the full shopping list for this job inc missalignment spacers
ta
yes, it is. But it does mean cutting and welding the after market linkage. Im currently working on adjusting the standard linkage to make it a short shift.
Shouldnt be too hard, just a matter of moving a few drilled holes.
My list consisted of:
2x female m10 rose joints (with 4 x spacers)
2x male M12 rose joints. (with 4 spacers)
1 x length of m10 threaded rod/studding
2 x m10 nuts
2x m12 bolts or studding
4x m12 nyloc nuts
2x m12 nuts.
I did not use spacers in the end, i used an m12 tube to sleave which worked well and was cheaper.
I have more photos at home, il upload them shortly.
Last edited by loggyboy; 22-10-08 at 01:41 PM.
Pics of my nearly finished linkage. it works fine, but as I mentioned, i plan on adding adjustments to change the throw distance, both side to side and front to back.
dar if i sen you a gear linkage will you make me one how much would you want to make me one
what sort of interest is there of these linkages? i mean how many people would want one?