PMSL ::Originally Posted by Razorjack
looks good nick
ps i also have a gsi lump for sale :wink:
PMSL ::Originally Posted by Razorjack
looks good nick
ps i also have a gsi lump for sale :wink:
progress is always good
why did u not get the block worked as you wanted?
are you looking to use standard bottom end and just rip off the injection etc etc then?
Those carbs will look nice with a bit of chroming, nice one mate
Leave them rough, if you smooth them you'll make it worse.Originally Posted by Nick?
It's designed rough as it helps to mix the fuel and air.
nooo, i know the roughness helps roll the air and keep the fuel in suspension, but this is quite a rough lip down each side of the port.
I will be paying a fair amount of money for it, and it's just not what i wanted to see.
I was going to get alot of work done on the bottom end , but if i can find a better condition one that just needs honing, i'l scrap the idea of getting it rebored with new pistons. It'l still have some lightening and balancing, ARP bolts e.t.c
Riggy what condition is your GSi lump in ?
good mate it was seans old one before he had the xe fitted
I too can vouch for that, it drove lovely
Chris