Nah wasn’t me that made the panels mate. And no Bruce I’m not painting them haha
Not been on here in a while. Few updates, engine’s been in and out a few times getting it in the conrrect position and getting the cut out at the front of the tunnel right. There’s a pipe on the transfer box that’s fouling at one of the steering rack threads. I’ve either to cut the thread and leave 3 for the steering rack and knock a bit up for extra support or chop a bit on the box, not decided which yet. Then can get the tunnel strengthened at the front to take another gearbox/ transfer box mount.
After that jsut need to fab to bits in the bulkhead and alternator cut out and the front end should pretty much be finished.
Just realised I’ve got nowhere to host my pics at the moment.. deleted the apps. Pics to follow.
Sent from my iPhone using Tapatalk
Any updates on this at all?
Currently engine is in on 2 mounts. Need to knock up the rear one. Tunnel is done just needs tidied up. Had to chop the pipe off the top of the transfer box to clear the steering rack. Not much fab work at all needing done. Made new rear suspension arms at work also. Need to fit them to get her rolling again. Had a hectic year though, hopefully able to batter on from this weekend!
Glad to hear it’s still coming along, these long term projects are testing!
Have you had drive shafts in? As the gearbox mount looks father forward than mine and i had issues.
All I wanted was a Pepsi, just one PepsiFar from suicidalStill I get them tendenciesBringing back them memories
That I really miss when I reminisce
Ah ok. I’ll have a gander!
nah not had the shafts in. Everything measurement wise seems to tie in good where it’s at but I guess I could try them in. Any pics of where your mount is for a comparison? Can’t go much further back or the gearbox will foul below the steering rack.