Some of you will want to fit these, but dont have the studs for the clips. Tiger seal is a good way, but i struggled with this. So i set about fitting the clips.
I have taken some pics and made a note of the measurements. I still have to do the pother side, so i will record any additional measurements needed.
You may have a better way of doing this, so feel free to add.
Pics...
These are the basic measurements for the clip locations. 20mm from the bottom of the sill should see the centre line for you screw holes. The skirt side has a channel of 40mm long. The screws need to be 30mm apart. Each skirt channel is a smidge over 6" apart. The rear fin section only has one clip location channel.
Also, the front wing holes need to be about 20mm in from the edge. The fixing for the rear fin is about 3.5" from the last clip on the long section.