ive got a couple of oil coolers laying around if thats any easier? Im just a bit far from you.
ive got a couple of oil coolers laying around if thats any easier? Im just a bit far from you.
Any pics of them mate?
Ive got two coolers.
One fits the sandwich plate fine, but the pipes are too long so it doesnt fit a nova too well.
The other fits the car perfectly but dont fit my sandwich plate
Old XE track car
http://www.pngclub.com/forum/showthread.php?t=74272
If you dont mind mateOriginally Posted by gaznovalet
Also, is there a part number on that Let one??? Looks different to the xe one on the left, so maybe thats an early type too...
Last edited by Adam; 11-05-09 at 09:56 PM.
Old XE track car
http://www.pngclub.com/forum/showthread.php?t=74272
Ad, the cooler you're wanting to use, is it the one i gave you? If it helps it's off a c20ne astra.
Yes mate
Old XE track car
http://www.pngclub.com/forum/showthread.php?t=74272
It's fooking typical isn't, i binned all the last bits from that scrap c20ne engine when i weighed that astra f in a couple of weeks back, including the oil pump and sandwich plate! They'd been in the shed for 2+ years!
Its always the case
BUMP!!!! This bit is holding up starting the bastid engine!
Old XE track car
http://www.pngclub.com/forum/showthread.php?t=74272
the let one part number is 11961/1Originally Posted by Adam
and the diameter of the bolts wich fit are exactly 10mm.
That sounds about right!!
Do you have the middle bolt thing that holds it to the oil pump???
Old XE track car
http://www.pngclub.com/forum/showthread.php?t=74272
i have a brand new sandwich plate and bolts and maybe the bolt that holds it to the pump need to look tommorow