get it test fitted dude!!
get it test fitted dude!!
Right fitting.
Sat on the cut out,
Ends from the out side,
From the in, should be ok with either an rubber elbow or a welded on elbow.
Looking down, you can see its behind the line from the irons.
Bit tight on the bumper, will shave a bit from the mouth and a lil more from the front pannel (see pic 3down)
Sitting right behind the cut out of the mouth.
Need to strighten this line up a bit, then it will fit a lil better.
All I wanted was a Pepsi, just one PepsiFar from suicidalStill I get them tendenciesBringing back them memories
That I really miss when I reminisce
I love it when a plan comes together!
if you trim the side flaps you'll easilly get some chopped down 90s in there without needing to weld the end tanks
Looks like it may work mate! are you going to run an f28? is so, make sure the elbow from the cooler to the tb will clear the f28 box mount!
Where'd you source the i/c benn?
Looking good Benn
Old XE track car
http://www.pngclub.com/forum/showthread.php?t=74272
Si: Theres enough room i think they will fit, but will if needed.
Dan: May work? Hope it will. Get on msn. No F20 for the mo.
John: Ebay, pm me for the link, hes got a really good shop.
Ad: Cheers. You want the link too? For yours.
All I wanted was a Pepsi, just one PepsiFar from suicidalStill I get them tendenciesBringing back them memories
That I really miss when I reminisce
Aye
Any pics of the cutout in your crossmember?
Old XE track car
http://www.pngclub.com/forum/showthread.php?t=74272
Yes go back a page.. theres loads...
All I wanted was a Pepsi, just one PepsiFar from suicidalStill I get them tendenciesBringing back them memories
That I really miss when I reminisce
Posting Permissions
Reply With Quote
