dash speakers

[1400_sri]

how do you get these ones out as ive been trying for a long time without any success, also am i right in saying that they are 4" and any upgraded 4" speakers should fit?

any help appreciated

[newboytothenova2]

hi mate wot dash have you got. m1 or mk2

if its a mark 2 take the glove box out ansd twist the original speaker out,.you can do this just by removing the air vent but its tricky if u have big hands .. the drivers side take the air vent out and twist the speaker out..sony do perfect fit dash speakers that fit the nova not alot of cash n make a difrence.. if its a mk1 its alot more work but neva owning 1 i carnt give advise but looking on ere most people stay clear of removing them

[boredbloke]

MK1's were a pain in the arse imo, do the same to begin remove the glove box, the speaker is held in with 4 screw iirc

to do the drivers side you need to go through the fuse box hole meaning u need to move it aside it isn't the esiest job in the world and replacing them is even more tricky

[1400_sri]

yeh it is a mk2, but how do you remove the glove box? is it an easy job or a pain?

[epo]

glove box is dead easy just undo about 6 or 7 of the bolts with a 10mm socket iirc

[19-NoZ-19]

i think its an 8mm socket you will need to undo them mate and theres about 6 of them :D

rick

[epo]

i think its an 8mm socket you will need to undo them mate and theres about 6 of them :D

rick

sounds about right been a while since ive played with a nova

[sickrabbit]

can be a beggar if you,ve big paws ...i did this a while back ..pulled off the dash speaker covers , then undo the air vents at the side , once free push the air vent location into the dash , reach up inside grip the speaker turn it and out it pops...i used pioneers 4 inchers to replace but before i fitted em i sprayed the back of em ( magnet only - doh ) with carpet glue and stuck a small " bung " of sponge on the back , just to keep things insulated and snug. The real hard bit was fitting em in , i had to cut some of the cardboard location away so the speaker was free to vibrate with no contact but once it was done i held the lot in tight with the help of a bradle and zip ties -all wired up and hidden under original covers ....connecting the air vent was a beggar but with a push n shove mated up as tight as a duck.
good luck and watch yer knuckles .......

[STE Novavanman]

i got mine out of my mk2 by removing the top cover of the grill and yanked them out i think you can get them out without removing the glove book by getting your hand up behind it on drivers side take das out and slide across piece of pizza

[ANDYRACER]

Just dont bother with the dash speakers and fit door speakers.