Oh I'm also putting digital dash in so yeah ill have rev counter
Sent from my SM-G988B using Tapatalk
Oh I'm also putting digital dash in so yeah ill have rev counter
Sent from my SM-G988B using Tapatalk
I made a start on putting bits back in and have a bash at the wiring.
I cut the 2 plugs for the car ecu and pulled all the wires through and I'm now left with
4 x lives
2 x ignition lives
1 x Green
1 x brown/blue
1 problem is the plug for fuel pump relay was removed from loom as it was some of the wires that I cut from the ecu plugs, do I have to rewire this back into the wires that are left over?
I'm confused now
At least the engine bay is starting to look like an engine bay
Sent from my SM-G988B using Tapatalk
Never mind my mistake the engine loom has fuel pump relay on hahahaha
Sent from my SM-G988B using Tapatalk
"If you want something done properly, do it yourself" as they say.
Good job on the paint. Looking fresh!
Cheers mate.
Yeah I prefer doing things myself, at least then I know it's done how it should be or at least how I think it should be
Sent from my SM-G988B using Tapatalk
Deffo... mind at ease and all that.
Bit more done today.
Changed the mileage on digi clocks to match the cars mileage and fit some blue bulbs.
Cleaned the tag and sprayed it then riveted both tags to slam panel.
Fit the loom back to firewall inside car, fit the heater matrix, put the clutch cable in, ran the wires into car for the digi dash.
Dash board is ready to be fitted now so can get the inside looking like a car again.
I'll do a bit more on Tuesday when I've got the new fuel pump for it.
My brake lines should be here next week so soon as I put them on I can start getting the engine in the bay, just want to paint the mounts first and need to get the spacers for rear mount
Sent from my SM-G988B using Tapatalk
Also while I was cleaning the gearbox up I noticed the arm has been bodge welded .
Will the arm from my f10 fit the f20?
Sent from my SM-G988B using Tapatalk
Remember to cut down the matrix pipe
Sent from my iPhone using Tapatalk
Yeah the matrix pipes are on the list to do
Sent from my SM-G988B using Tapatalk