Amazing work so far. That front end should stand some serious power!
Amazing work so far. That front end should stand some serious power!
Awsome work that mate . Them bottom arms look the buisness
Pornographic welds as usual. Top work.
Sent from my Nokia 6310i using the keypad
One day I'll start a build thread. One day...
Fab looks fine, however since you are sharing this publicly I can only advise redoing the chassis mounts to AT LEAST run the 1/2" bearings in the vertical not (as you have it) horizontal plane.
Generally people really dislike such input for two reasons:-
1] Who the f is this guy & what would he know?
2] The work is now done & f redoing it
So I'll just speak from real world experience.
I've broken a VERY similar RJ arrangement this year, under load at just 70MPH; granted it was during braking, but if you're pushing 200MPH this would not be anyway strong enough imo.
I now run these 3/4" bearings & have made sure the load runs through the round section of the bearing, as they were intended when designed. (Can only report good things).
And it’s ready to come home, for now.
Can’t wait to see it
Sent from my iPhone using Tapatalk
As you can see the custom billet rear hubs (not 100% finished) from VauxPro are now on and Ben has completed the rear axle.
Very happy with how the rear end has come together
Sent from my iPhone using Tapatalk
Looks awesome fella, cant wait to see the progress on this now its back... surely with all the bits you have it'l just be a giant meccano set?!
If Carlsberg did Motor clubs, then IDMC would probably be the best motor club in the world.
Time to get a few bits put on and see how it looks
Sent from my iPhone using Tapatalk
Unreal !!
good work mate