20xe conversion running issue

[AndyRandz]

What code is on the ecu?

Lambda sensor or not?

You are correct, 20xe loom has 2 earth's from the inj rail not 3 like the later looms.

Tried a different maf sensor?

No lambda sensor.
I have tried f and g series Ecus to same effect.
No I haven't, that's about the only sensor I haven't switched out.
Doesn't make any difference when connected or disconnected as I've tried that to see if there was any impact.


Sent from my iPhone using Tapatalk

[AndyRandz]

Quick update. Had a quick hour on it today. Checked all earths and cleaned. One wasn't great but again made no difference to running issue. By looks of things next thing I ca do is take the entire loom out and check/rebuild. Really am suspicious of something as daft as a broken wire, the loom has presented other issues that points to this. Wish I'd have just bought a set of carbs and been done with it now!


Sent from my iPhone using Tapatalk

[AndyRandz]

Anyone any ideas why I'm getting nothing out of pin 22 EML light.. I've tried different Ecus and still nothing


Sent from my iPhone using Tapatalk

[paul080803]

I have a good 20xe loom for sale

[AndyRandz]

I'll take it off your hands. Pm me please mate


Sent from my iPhone using Tapatalk

[AndyRandz]

Running at last. Faulty octane switch. Thanks guys


Sent from my iPhone using Tapatalk

[totalnova]

Glad you got it sorted in the end.

[AndyRandz]

Thanks bud. Felt like I've been going round in circles all week. Still not 100% right though. She hunts a bit on idle. Slightly too high and doesn't like throttle being applied


Sent from my iPhone using Tapatalk

[AndyRandz]

I can rest my foot on the throttle and rpm doesn't really increase. It just sounds like it's misfiring


Sent from my iPhone using Tapatalk

[AndyRandz]

Anything real throttle pressure applied it just cuts out


Sent from my iPhone using Tapatalk