I would be interested to know the measurements on each knuckle from centreline of bearing to top of TCA taper. The lowered ball joint will help with correcting the roll centre if you intend to lower the car much, but in my experience 2.0 Nova's handle great at a sensible height.
That 1 measurement alone on mine is 25MM, but that's not a whole truth on the correction. The bespoke arm itself effectively raises the knuckle too thus sharing the stress.
I meant the OP's picture of a late Corsa item.
OP's picture?
Yes he posted a photograph comparing a Nova knuckle to a late Corsa one.
Posting Permissions
Reply With Quote