Results 1 to 3 of 3

Thread: Welding on new rear quarter.

  1. #1
    Junior User
    Join Date
    Nov 2010
    Location
    west brom
    Posts
    71
    Post Thanks / Like
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)

    Default Welding on new rear quarter.

    Hi guys, not been on for a while had other stuff going on so the nova took a backseat for a while. But the time has come go get cracking because I want it on the road for the summer and there's a lot to do. I'm going to be purchasing 2 new rear quarters and inner arches for my gsi. Pattern parts. In er arches ain't a problem but I'm wondering which way is best to go about fitting the rear quarters. Any advice would be very appreciated. Thanks

  2. #2
    User
    Join Date
    Jan 2004
    Location
    Ash vale, Hampshire
    Posts
    1,471
    Post Thanks / Like
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)

    Default

    I'm sure the was a build thread not long ago where some one was replacing the whole rear quarter panels on an Sr I think it was, just get the grinder out and the spot weld drill and attack the rust.

  3. #3
    User
    Join Date
    Sep 2014
    Location
    boston
    Posts
    104
    Post Thanks / Like
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)

    Default

    Best way to do your quarter offer it up and mark roughly where it wants to be cut start at the bottom because use your sill as a start point then the more you cut out the more it fits etc on the way up till you get to b +c pill then lots of mole grips and cut it in hope that helps

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •