Mmm not rocket science :D
Mmm not rocket science :D
Make it so that you can still fit it between the legs of an engine crane. youll kick your self if the engine crane cant get far enough in to lift the car on and off the spit
optimum pivot point/centre of rotation is the middle of the car. just measure the width from the middle of the car to the end of the wing mirror which is like 95 cm plus 10 cm clearance and you have the height of the pivot off the ground.
also its better to make the floor supports removable so it stores away up against a wall.
Last edited by therealnovaboy; 18-11-15 at 09:12 AM.
Twags old one if your wondering what it looked like:
http://www.pngclub.com/forum/showthr...-roll-over-jig