Is it possible to wire this dash to a mk1 loom and c20xe engine so that oil pressure/temp, water temp, speedo and tac all work. Also indicators and handbrake light etc
http://www.demon-tweeks.co.uk/motors...l-dash-display
Is it possible to wire this dash to a mk1 loom and c20xe engine so that oil pressure/temp, water temp, speedo and tac all work. Also indicators and handbrake light etc
http://www.demon-tweeks.co.uk/motors...l-dash-display
It comes with it's own sensors, so you'll be using them rather than the original ones.
You can reuse the wiring between the dash and the sensors.
I imagine it'll be a minor ballache, and there'll be minimal plug and play installation, but it should work fine. Worth looking what it uses for a speedo input as you may need to attach something to a hub/brake disc
As above, As long as you fitted the right sensors you could get it all working.
I would personally pay a bit more and get a Race Technology Dash 2 if its for a road car
http://www.race-technology.com/dash2_2_31.html
Im guessing it will just be a case of finding out what goes where. I may have a look at that one too. Depends on what cash i have at the time ill be wanting it