And off with the rot
And all the rust that fell out as I was removing it
Then lining the new panel up
also with the metal I removed ( rusty stuff ) I cut small lengths from roughly the position they were in and stuck them to the inside of the rear quarter so I could get the same shape joining the new panel if any of that makes sense ahha
Pulled them off when finished
Looking good mate
Neat job!
Regards
Royston
Sound job mate!
did you get the cage in okay?
Havnt attempted it yet mate I put it roughly in but think I'll have to make beds for the feet of the cage to sit on engine out next then I'll get the cage in just trying to save money for a respray I didn't realise how much it would cost haha
Now up for sale £1400 takes it need gone asap