ok, I need to check the lower ball joint, jack up car and move joint looking for play?
there was no play noticed for MOT in April but maybe there isn't enough movement for them to have noticed.
ok, I need to check the lower ball joint, jack up car and move joint looking for play?
there was no play noticed for MOT in April but maybe there isn't enough movement for them to have noticed.
do you have fixed or adjustable top mounts
It's all standard so i assume that's fixed
I jacked the car up today and had a probe. The ball joint on the passenger side has movem,ent so i assuem that's the noise.
It is moving within the pinch of the hub, is it the nut and bolt that has to be replaced and the pinch heated so it moves in tighter or do the ball joints get slack at this point with wear?
If it is putting on a new balljoint which looks easy enough, does tracking etc have t be checked afterwards or should it all be fine?
Thanks
It depends if it was tracked when if it had the play in the balljoint or not. if it still drives straight chances are itll be fine.
Also check its not the hub taper thats worn. if the pinch bolt has been loose a while, it could have wrecked the taper.
yes all the hubs are the same inc corsa B.
you could pull out the balljoint first. if the pin looks ok and it tightens when you nip up the pinch bolt you might be ok.
did you try and nip up the pinch bolt? you might want to pull the bolt out out and clean it up then re tighten it. the threads might be goosed. At least you can do that without taking the wheels off.
you might need two jacks as the ARB might pull the balljoint out the hub and its a d!ck to get back in if you only jack up one side.
I might be havering