Hi all,
I have finally got some spare time to post my current winter project. My old 1.4sr nova has finally been defeated by rust and time to build a new toy. I fitted this with twin 40's and full respray and some minor cosmetic changes as shown below.(mirrors missing)
So as I said I began the search for a new donar shell to drop a 2.0L lump into. Came across a K-plate 1.2i swing in the autotrader about 3 years ago which seemed to be in good condition for the conversion. So travelled down to see it and brought it back home. However, it has been sat under cover until a couple of months ago when I have finally decided to do something with it. Over the past few years, I have been collecting all the bits and bobs I need which for the build. I think I have almost everything I need so below are a few photos of the donor car stripped and the engine as I bought it for the car etc.
The swing stripped:
New front panel area bad with rust so needs replacing:
Bought the engine from a guy who was planning to build a similar build but then got offered an turbo engine so after tdoing a total engine rebuild, sold the engine to me along with some other bits n pieces:
Engine Block:
Think I am right is saying the alternator pulley needs changing??
Other parts which came along with the engine:
The photo's are slightly out of date just now as I have had the timing belt cover and rocker cover powder coated whits and painted up the rest of the engine. Will post some snaps when I take them.
So that's a quick introduction. I need to take more photo's and get them posted with all the parts I have.
Current sistuation with the car is as follows:
Folling a previous post on the forum, I found a guy though in fife (Scotland)who was able to stich weld the car and fit the strengthing kit. CHIZFAB which I found to be really good and helpful. Would recommend if anyone is needing the same done to their car in this area.
Picture of car heading through to be welded:
Its now back and currently in the paint shop where it has been given a full new front end, 2 new front wings, both rear arches replaced and rolled for the 17's, all bodywork flattened, primed and will be sprayed in black just the same as my old nova.
As I said, I will post some more photo's hopefully next week to keep you updated. If anyone has anycomments or advice....please let me know.
Cheers
Robert