Hi guys ill have a look tomorrow and try and upload a pic to show you. I know on the very top of the selector casing has a cap on it, a black one. I removed that and the plug from the top to fill it up.
Hi guys ill have a look tomorrow and try and upload a pic to show you. I know on the very top of the selector casing has a cap on it, a black one. I removed that and the plug from the top to fill it up.
Yes, but did you put them back after?
did you push the black cap all the way on, or to the 1st click? as this is also the breather vent
Yeah done that, gonna try and put picture up now if it works.
I have put a screw just to show where I think it's coming from. The screw will go all the way in. Should that have a blank on it??
Please excuse how dirty it is at the moment.
Also I pushed the black cap all the way is that a problem???
that hole should have a small spring loaded plunger in it, to aid setting up the gear linkage. either fit another turret with the plunger, or bung the hole up with something (a blob of silicone would do)
the black cap on the breather should only be on part way, to allow it to breath properly. if its rammed on tight, it will be sealed, and it will be forcing oil out through some other orifice, it this case, the hole you have pictured
Cheers for help, I'll see if I can purchase this plunger thing.
part no is 90523130
pull the little black cap up so it isn't all the way on, that's how its meant to be.
Posting Permissions
Reply With Quote