Machining in Aberdeen

[marc69]

That's perfect, thank you, I'll probably turn up lunchtime on Monday then if that's ok. How you getting on with your car?

[bazzap8389]

Aye that's fine, haven't touched it in a few weeks tbh just don't have the time just now

[marc69]

I am just unmotivated at the moment! See you Monday.

[EwanG]

Ah ok, my work is Ajt engineering it's on craigshaw crescent in tullos, next to the BMW garage. Drop it off anytime and I can get on it when ibe got spare time then I'll drop it off to you at your house if that's ok.

Out of curiously what machine shop did you put it to?

Dont mean to spam this thread but my work does steel rolling jobs for AJT (usually me). I work at Gray fabrication in Cupar fife

[bazzap8389]

^ ah ok don't think we've had any of them recently though, If its the bigger rollings 50" dia upwards it would probably be me maching them. My least favourite job tbh

[bazzap8389]

Did it fit ok mate?

[marc69]

DROVE MY SR TODAY!!!!!! Thanks to Bazzap, I dropped the manifold off and just over an hour later got the call to tell me it was repaired, an hour after that it was delivered, true service! Thanks

When refitting the manifold I noticed a little bit of bad paint on the cross member, guess what............yes, I managed to get a screwdriver through it, I'll leave it to next week and get the welder out.

[bazzap8389]

Good to hear it went together fine! If you need anything else machined etc just give me a shout, happy to help

[novalovingned]

That's service Baz

[bazzap8389]