Plow bumper fitting?

[scott.parker]

Right, I'm after pics and some advise on how your meant to fit them properly, would like to see pics of the bit/parts you have to fit them.

Also has any one got pics of the screw cap's/cover and any sizes etc?

All help would be very much appreciated, cheers.

Scott

[Southie]

They're held on by little clips like a u bend that have a hole either side and the a screw to nip them up, covers are covers and all the clips and screws and covers are rare as feck Scott. I bolted my old one underneath from where the old bottom lip valance use to fit.

Best making some brackets to fit tbh.

[MK999]

Fluoro orange cable ties in a criss cross pattern

[mayhem]

I have a set of both on spare, not selling it though.

I'll get some pics up tomorrow

[Calamity Josh]

Caps for the screws:

You can see a clip here, it had metal and plastic ones?

Heres a plastic clip, it screws on at the screw hole with the cap and bends round clipping into the bumper iron:

You can see here how it clips in:

Hope this helps?

[Mike]

Has anyone got any clearer pics of how these fit at all???

[Calamity Josh]

my ones show you all you need to know?

[Novasport]

[scott.parker]

I think what mikes asking is, could you posibly show a pic of the clip clearly and on it's own, and how it fits into the bumper bar etc?

And how they attach on the side/wing part also.
Cheers.

Scott

[scott.parker]

TBF Rich them diagrams with unclear text make less sense then the last set of pics!