Been on going since 2003 in various disguises..
I have lots of old pics on my old lap top over the years, which i need to time line.
But for now, i have an update worth showing..
This is an inlet manifold ive had for me. its been built from scratch on a std LET manifold which was cut back.
I have done various research into the making of this, and the fabricator is looking to sell these in the near future.
Its in an unfinished state, next stage is to add an end plate for the V6 throttle body then send it to the polishers to finish.
Im now debating removing the firewall, hiding everything and smoothing it all out. The engine bay needs another repaint anyway after fitting the F28.
Engine runs on Omex 600, GT3071R Turbo on a Nortech Manifold, Steel Rods, F28 with a quaife diff and equal length shafts, 3" Turbo Back Exhaust, Front Mounted Intercooler.
Any opinions and advice appreciated on all aspects of the engine and whats being done.