Yeah I know, I had the same setup before I got gaz.
Yeah I know, I had the same setup before I got gaz.
Thats right shÃ*tOriginally Posted by AlexW
every one Ive ever seen fitted the, adjustable platform is mounted at the bottom onto axle, makes SOOOOOO much more sense!
They've probably copied a bilstein design for rally or similar, adjusters at the top mean they're sprung weight.
these tiny alternators are usually from kubota engines(or similar), as used in that crappy aixim thing, and also mini diggers, compact tractors etc....
Been mincing about lately... picked up this contraption. Will take to work & blitz it down on a lathe Monday.
Anyway, removed all one etc etc cleaned & that, pre assembled to find the following...
Theres a huge gap :/ that was full of road crud :/ obviously its not an interference fitment so whats the deal with this gap being cunnigly pointed out by a pointy piece of carbon
The central cirlce metal insert is removable (for those who didnt know), but refit it and it leaves a huge gap? What do you here, pack it with packing grease/copper slip etc to stop crud ingress?
i thought you got bored of this and weighed it in
It's just a giant washer to hold the bottom pulley to the crank, if you tried to fit it without that it'd slide over the bolt. Fairly sure the pulley sits over the washer.
Yeah I know what it is like
Also done some other mundane stuff today.... an bought some more bits this afternoon..... funkaaaaay
I thought the same, what was with the change of mind Mike then?i thought you got bored of this and weighed it in
1. why not, would be with any other washerYeah I know what it is like
2. By "pulley sits over it" I meant the gap. Pretty sure the ID of the pulley is smaller than the OD of the bolt.
Reply With Quote
