no worries fella.
no worries fella.
Quick question.
Does the sealer need to be applied to the inside of the rubber seal and then the screen slotted into the rubber or slot the screen into the rubber and then apply sealer under the rubber?
Good chance the screen is going in tomorrow just need to know
Yes^
Has any one got there's wired up and working? As mine is and takes current from the battery but not 100% sure if its doing anything..
All I wanted was a Pepsi, just one PepsiFar from suicidalStill I get them tendenciesBringing back them memories
That I really miss when I reminisce
Yes, what? I wrote two different methods there.
Mines not wired up just yet, was gonn ask actually.
The screen has 4 wires. 2 on the left side of the glass and 2 on the right side. Is it one lot of wires earthed and the other 2 switched live?
The screens are divided into the left half and right half, which are isolated from one another. One from each side needs to be earthed, the other needs to be switched live. It doesn't matter which way around you do it top/bottom.
oh right got it. So for example: Left and right bottom wires to earths and the other two to the switch?
Yep.
Yes the rubber needs to be filled with sealant then the glass fitted,
1 ground and one power each side.
No one else got there's working tho?
All I wanted was a Pepsi, just one PepsiFar from suicidalStill I get them tendenciesBringing back them memories
That I really miss when I reminisce