I've searched, and have not been able to find anything concrete. (i think i've personally asked before, but couldn't find it Lol)
Right, i have a good 1.3, with a fooked head (looks like its been skimmed with an angle grinder), and i also have a very good 1.2 with the same cathederal shaped ports. Will it fit ok on the 1.3 block, i presume i use the 1.3 gasket?
Also I'm planning on fitting a weber, and possibly some sort of better cam, is the 1.4 cam better than the 1.2/3?. Will it be ok to use with with the block/head combo?
Any help greatly appreciated!