when the servo is removed can a servo blanking plate found on the left (looking under bonnet) be used to blank the hole ?
when the servo is removed can a servo blanking plate found on the left (looking under bonnet) be used to blank the hole ?
no.
could get a big ass rubber grommit for it ?, or alternatively weld a circular plate in the hole. or make your own blankin plate with studs pressed into it so u can bolt it in.
Last edited by jimbob-mcgrew; 28-11-08 at 10:34 PM.
Piece of MDF & some no-more-nails.... a squirt of Satin Black later....
Pikey motorsport TM
thanks for that
i dont understand why both the holes are different though
Different pedal assembly entirely with the R/hand drive I should think.
i got the plate off the back of the std mastercylinder/servo and plated he hole up in the middle of it and then used the std bolt holes to bolt it back on
i also thought te opposite side plate would fit but it didnt
phil
I will be using the standard mount for the servo with a hole drilled through a welded plate similar to the above. Hole will be for Some of the wiring loom