Page 3 of 3 FirstFirst 123
Results 21 to 26 of 26

Thread: C20LET Fault 21 and idle at 1500rpm.

  1. #21
    Senior User Ben's Avatar
    Join Date
    May 2002
    Location
    New Zealand
    Posts
    9,554
    Post Thanks / Like
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)

    Default

    repost

  2. #22
    Senior User Ben's Avatar
    Join Date
    May 2002
    Location
    New Zealand
    Posts
    9,554
    Post Thanks / Like
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)

    Default

    Im getting sad now, but just incase you didnt know...


  3. #23
    Senior User
    Join Date
    May 2002
    Location
    N.Ireland
    Posts
    5,785
    Post Thanks / Like
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)

    Default

    Quote Originally Posted by Ben
    Keith

    Wire1 Brown blue wire goes into the Camshaft position sensor wire which is blue green (wire 3)

    Wire3 on the tps is brown green and that goes into the ecu pin 53 as above and the other wire is the earth and it shares the earth on pin 30 see below
    So that would say to me that the wire most likely to be dead is the brown/green, because it doesnt share this wire with any other sensor?

    This gets more confusing than I thought...

  4. #24
    Senior User Ben's Avatar
    Join Date
    May 2002
    Location
    New Zealand
    Posts
    9,554
    Post Thanks / Like
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)

    Default

    by process of elimination yes it would say that, but do what the troubleshotting says and get a multimeter across the pins in the plug to check it, the wire going to the CPS could be off as iirc you had the loom custom made so could be a dodgy solder or similar,

    I think its straight forward but i got the diagrams sat in front of me .

    Fancy looking at the din data on the 1.0 corsa c and the astra gsi turbo as they share the same ecu but just use different pins lmao

  5. #25
    Senior User
    Join Date
    May 2002
    Location
    N.Ireland
    Posts
    5,785
    Post Thanks / Like
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)

    Default

    Could be, will check that tomorrow after the purchase of a multimeter. Thanks Ben!

  6. #26
    Senior User Ben's Avatar
    Join Date
    May 2002
    Location
    New Zealand
    Posts
    9,554
    Post Thanks / Like
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)

    Default

    No probs mate, need anything else i will have a browse but tbh think thats all there can be.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •