Heating System Cover

[thedjse]

I think think this is in the right place

Anyway i have a single wiper conversion but the arm knocks the hell out of the cover for the heater in the bulk head so i took it off is this ok?

Also its scraping just a tiny bit on the back of the bulk head so i wanna drill a little hole just to stop it scrapping

What do you think guys

[craig green]

Sounds like the single wiper is a bodge.

[Dod]

The Cover, being the 1/2 round Black piece that clips into the black piece under the blower? If so, no its not alright as it wont draw in a saficiant amount of air. As for the scraping, dont drill it as it'll allow water into the cock pit. Hit it a few taps with a hammer to make a dent big enough to clear the wiper linkage.

[thedjse]

Thanks Dod mate what about the cover should i cut a hole in the cover to make it slid through?

[Dod]

Can you post a picture of the cover, the linkage and where they make contact please?

[thedjse]

i will do yeah when i get home

[Dod]