Just wondering if anyone could shed some light on my issue.I am running the Nova Gsi 6 Dial clocks in C20xe when I first start the car the volt gauge seems to sit low I have to rev the car up in high...
Type: Posts; User: jonnyd61; Keyword(s):
Just wondering if anyone could shed some light on my issue.I am running the Nova Gsi 6 Dial clocks in C20xe when I first start the car the volt gauge seems to sit low I have to rev the car up in high...
Yes the sender is a two pin one One side plug and other side just a push on connector like off the cavs an calibras that run the oil pressure gauges
Looking for some advice on why my oil pressure gauge sits at full all the time. I?m using mk2 6 dial ones
my oil pressure sender has two wires going to it one is the black plug (blue/green wire and...
I had to take some Material off the back of the hub jobs seems a good un now
Ye fella seen it I’m guna take it back apart an see what I can do wit it
Is ther anyone using meriva 5 stud front hubs I?m having an issue with the hub touching the knuckle.
iv had the hub machined down to use nova bearing so im using the nova knuckles. Alls good when...
what did you use to fit the skirts fella ? tiger seal ?
had a quick look and seems to being coming from some were osr upper of the tank couldn't see much to be honest. I used a small mirror an i can see two small pipes up the side im going to take the...
Today I jack it up on near side front to do some work went abit higher then usual an noticed fuel leaking from off side rear end of tank so going to investigate in the week maybe dodgy filler neck...
It’s not only when the car is running I can rock the car back and forth and a few seconds later there will be a strong smell of fuel in the garage but I can’t see any leaks or anything it’s like once...
No tank doesn’t look wet for what I can see .all lines are dry an breather looks in good nik
mybe a tank off jobby :cry::(
Just wondered if anyone could help I am getting a very strong smell of fuel from the car I?ve checked all the fuel lines and there are no leaks drips ect everything seems dry. When I jack the car up...
Thanks
Can someone point me in the right direction for the 5 stud conversion guide
was told there is a guide on here
still for sale ??
Yes mate
Hasn’t gone one mate ?
(C20let fresh rebuild) I noticed that my breather on my rocker cover is sucking air in not pushing it out Anyone else had this problem ??
Standard bolts going to drill the rivets out
C20let head bolts torque setting please (nm)
Using standard z20let head gasket
iv heard horror story's about the nylon valves messing up ??
Doing a full build on my clet was just wondering is it worth up grading the oil pump gear ??
Are standard rods good for 280-300 ??
Do you have a link for the rad on ebay mate ??
Got my first C20let just after some advice going to be doing a full rebuild hoping to use the EDS phase 2 chip just wondered what do people recommend mods to the phase 2 chip looking to hit 250ish...