Sadly due to purchasing a house i will be unable to finish my project, I'm offering my Throttle bodies and management for sale,
Whats included:
MegaSquirt V3 management built by Phil at...
Type: Posts; User: darragh792; Keyword(s):
Sadly due to purchasing a house i will be unable to finish my project, I'm offering my Throttle bodies and management for sale,
Whats included:
MegaSquirt V3 management built by Phil at...
Why use corsa c ball joints? To be fair I don't want to take it to far at the minute would like to get a few track days in and take it from there
My thinking is that if i want to lower the car slightly at the front the corsa hubs would in theory help with the arm angle
Going to get my hubs machined for larger bearing but I have 2 pairs the standard nova items
http://i1300.photobucket.com/albums/ag98/dohanlon792/Nova/20170518_190425_zpspculugjc.jpg
and some...
Drivers seat is sorted now, moved the mount of a bit so i clears the cage no problem. No its like a burgundy colour at the minute but it will be getting painted soon tho I'm unsure what colour either...
drivers side in tonight
http://i1300.photobucket.com/albums/ag98/dohanlon792/Nova/20170516_231710_zpsoduhdev5.jpg
Then seats are a bit to wide but they will do for the time being, got them for...
thanks rich.
That's the lowest I can mount them while able to weld underneath them, the column is moved over its straight but not dead centre...
got the passenger side seat in, awkward enough job measuring evrything a 100 times
http://i1300.photobucket.com/albums/ag98/dohanlon792/Nova/20170514_201348_zpsrnvxcdjo.jpg...
going well, looks like good fun having two similar cars to go on a track day
some tie bar brackets ready for the rest of material coming
http://i1300.photobucket.com/albums/ag98/dohanlon792/Nova/20170512_200203_zpscnfaicmu.jpg
been chipping away at various jobs on the nova, waiting on some front feet getting folded up so I caneed weld them in and bolt the cage to
...
Anyone have any ideas for the oil cooler lines, got some an-10 90 degrees fittings but the hose sits to tight to the wheel on full lock with 20mm spacers on??
yes I meant the braces in the rear, good to hear. Keep up the good work
How do you rate the rear anti roll bar?
Thanks, can't to get the first run it it
It's alive! Was initially hard to keep running but adjustEd some settings and balanced the throttle bodies. Idle is sitting around 1500 rpm so need to try and lower that but apart from that all is...
so close to starting tonight but didn't have time for all the small jobs, one last push tomorrow
http://i1300.photobucket.com/albums/ag98/dohanlon792/Nova/20170420_233319_zpsjo6ufavd.jpg
...
That's just it sat in but I'm welding in the mounts for it and want to keep it low, suppose I'll be able to play about with the side mounts
going to get a 6 point one, more than likely bolt in. I may just remove the bracing as it runs over the exhaust tunnel and keep it in place between sill and tunnel
Haven't been on in a while and haven't got much done to the nova due to other commitments namely
http://i1300.photobucket.com/albums/ag98/dohanlon792/Nova/20170312_142120_zpsltt0siyd.jpg
...
Bolt in roll cage that go's behind the dash preferably
.
Getting there slowly but surely, I've now have 90% of parts to complete it bar seats and harnesses.
should be a busy Xmas ...
Bump powercap sold
what spacing are the injectors ports on the same as standard?