Any chance of a photo to show how you did it
Type: Posts; User: dan23; Keyword(s):
Any chance of a photo to show how you did it
who s got one
I d like photos of how its been made
warm it up with a heat gun get your nails under it an lift it up it takes a while but you sctrach your floor but you will burn your hands
I have an old skool bolt on boss its massive an pushes the wheel closer to you
Maybe you could fit vertical door handles down the side of the polycarbonate windows
look at Honda civic rear door handles I think they are plastic too so should be light weight
you can buy them in machine mart they call them a swan neck cost a bit less than 20 quid iirc
not sure if the Clarke models will fit sealy though
these are still on the shockers so collection only from near leeds quite sure one of the shockers is nackerd
£!5 collected
I have all the bulbs from mk2 poverty spec clocks you can have them for postage if you still need them
What polish + other products would you recommend
Does the vapour dash have extended wiring for car application
Any news on this dude
You can still weld ok with co 2
if your welding thin metal you need to turn the settings down . Min 1 will weld it with out blowing holes using either co2 or argon
practise first on some plate...
Do you have front part of the dash can I buy the warning light symbols
Can someone add some photos of how the throttle cable should be routed I don't have one on my build
Try a proper stud extractor it's like a socket with a hole in in tightens when turned anti clock wise
don't think you will get them out with grips I could be wrong though
you could tack a nut to...
There was a member on here a few years ago that had a swift powered nova rally car
he may be able to help
think his user name was/is asw rally
The cover only goes on one way if I remember correct there is a raised lip on the cover that goes over the metal lip on the scuttle
try a corsa heater motor I think mk 1 s have the same motor but...
Don't get gas less they are crap
Clarke welders from machine aren't bad an if you wait until their no vat sale you will get it cheaper too
Egr will give similar symptoms
not sure how difficult it is to remove on Hyundai s
remove an soak it over night
Does the sale include gutter trim though
you should start a build thread for yours in the project section
welcome to the forum :thumb::thumb:
I have old Skool snap off boss it's quite long I m willing to swap it for a short one if anyone is interested
Sara Thomas on the auto grass page on Facebook
Sticking egr valve maybe
did you get this sorted
any photos of the install
But are all of the warning lights negative earth
( earth all the new lights to chassis an run the the wire from the dash plug to the appropriate bulb)
but this will only work if they are all...