Lockdown has been good for some after all :thumb:
Printable View
Lockdown has been good for some after all :thumb:
Levelled up, Simps!
Woooo hoooo! [emoji16][emoji16][emoji16]
Sent from my Nokia 6310i using the keyboard
This is a good motivation boost for you. Looking good
Sent from my SM-G950F using Tapatalk
Loving the turrets.
So good to see the shell on it again
Thanks Benn. Front end has now all been welded. With work busy again I've not had any real significant time on it but I have next week off, so hoping to dedicate two full days. I want to make the tag points for locating the shell so I can remove the exoskeleton that is around it, get engine back in and figure out the bulkhead, and finally cut away the rear arches for clearance and I can actually put it on its wheels rolling again :)
I've ordered a new seat too - hopefully this one fits! 6 week lead time tho :(
Sounds like a plan.
Is going very well
So in the last few days I’ve done some chopping (rear wheel clearance), made some temporary brackets (locating the A pillars), and chopped of the exo-skeleton that was around the body!
https://uploads.tapatalk-cdn.com/202...8496250e55.jpg
https://uploads.tapatalk-cdn.com/202...7b00a8fdaa.jpg
https://uploads.tapatalk-cdn.com/202...3867568f49.jpg
https://uploads.tapatalk-cdn.com/202...71f7e09347.jpg
It’s looking a little more Nova like now!
I almost took it off the jig just to see it on all 4 wheels and under it’s own weight, but would only have to go putting it back on the jig again. So I didn’t! [emoji1787]
Fuck yes!!!!
Crack on
Whats the plan for arches then? Wide saloon-shape steel?