Well no swirl pot from what I can see and this is the sender so I guess it's had its tank changed.http://i1050.photobucket.com/albums/...psaymto9e4.jpg
Printable View
Well no swirl pot from what I can see and this is the sender so I guess it's had its tank changed.http://i1050.photobucket.com/albums/...psaymto9e4.jpg
If they're the same internally then I guess you can use either for a carb!
No refunds.
Today I got my new fuel tank to neck breather hose and a couple of aftermarket side repeater kits from euro car parts. These seemed a lot cheaper than what people where asking for for 2nd hand ones.
http://i1050.photobucket.com/albums/...psuslnqqem.jpg
http://i1050.photobucket.com/albums/...pst20xqopj.jpg
Eurocarparts quality isn't as good since it was sold so I prefer genuine
Well I was hoping to pick up a good used set but cannot justify paying £15 to £20 for them. I will be in the market for a mk2 grill and noticed they also sell a aftermarket one but cannot see any pictures of it. That's priced at £35 mind so is that going to be poor quality?
http://i1050.photobucket.com/albums/...pskrczmrtp.jpg
Looks like it will be bit of a rep after all! These are in very good condition and are in keeping with the car so went for them, was going to go for a digi but the prices are just stupid these days.
Also got hold of a 1.3 inlet and dizzy from Josh so very happy, getting all the important parts now.
I can't see the side repeaters you bought front the euro car parts on their site?
Still there, just checked. Under electrical and then indicators. That was using my reg tho
So just a small update from last weekend. Decided to get the front end running gear stripped off the shell. Looks like it needs a rub down and few coats of paint to freshen up. Have found that the lower arms have been strengthened by the previous owner so helpful if i decide to upgrade later down the line.
http://i1050.photobucket.com/albums/...pslnovdohj.jpg
Having problems with 2 of the nuts on the anti roll bar clamps as they are seized on and rounded off!!
Also after having to dig out the impact driver I got the fuel filler pipe out. Again well corroded but should come up fine.
http://i1050.photobucket.com/albums/...psw1qfkymm.jpg
http://i1050.photobucket.com/albums/...ps7n4g43rg.jpg