PDA

View Full Version : Heating System Cover



thedjse
07-07-08, 12:29 PM
I think think this is in the right place

Anyway i have a single wiper conversion but the arm knocks the hell out of the cover for the heater in the bulk head so i took it off is this ok?

Also its scraping just a tiny bit on the back of the bulk head so i wanna drill a little hole just to stop it scrapping

What do you think guys

craig green
07-07-08, 12:57 PM
Sounds like the single wiper is a bodge.

Dod
07-07-08, 01:10 PM
The Cover, being the 1/2 round Black piece that clips into the black piece under the blower? If so, no its not alright as it wont draw in a saficiant amount of air. As for the scraping, dont drill it as it'll allow water into the cock pit. Hit it a few taps with a hammer to make a dent big enough to clear the wiper linkage.

thedjse
07-07-08, 01:14 PM
Thanks Dod mate what about the cover should i cut a hole in the cover to make it slid through?

Dod
07-07-08, 01:22 PM
Can you post a picture of the cover, the linkage and where they make contact please?

thedjse
07-07-08, 01:28 PM
i will do yeah when i get home

Dod
07-07-08, 01:34 PM
:thumb: